Casa Padrino News

Side Table with Metal Base on Parquet: Permissible Weight

by admin - 5 Nov, 2026

Side Table with Metal Base on Parquet: Permissible Weight

Side Table with Metal Base: What Weight on Parquet

You would like to place a side table with metal base on parquet flooring and wonder whether the weight will damage the floor? Parquet is robust, but not immune to every load. Particularly point loads from narrow metal feet can leave pressure marks or dents. How much weight your parquet can bear depends on the wood species, the processing and the contact area of the feet.

What Load Can Parquet Generally Withstand

Parquet made from oak or walnut withstands more than soft coniferous wood. The critical limit is usually a surface pressure of approximately 2 to 3 Newtons per square millimetre. A side table with four metal feet of 2 cm diameter each distributes its weight over approximately 12.5 square centimetres total area. A table with 15 kilograms own weight plus 10 kilograms decoration then generates a pressure of approximately 2 N/mm², which is still within limits for medium-hard woods. With soft parquet or very thin feet, the risk increases.

When Do Felt Glides or Pads Become Necessary

As soon as the metal feet have a diameter below 1.5 centimetres or the table becomes heavier than 20 kilograms, you should use felt glides. These increase the contact area and absorb movements. Ensure that the glides adhere firmly and leave no adhesive residue on the parquet. For very fine or freshly sealed floors, a thin rubber or cork pad placed under the table is additionally recommended. This also prevents scratches when moving.

Guidelines for Safe Placement

The following rules of thumb will help you assess the situation:

  • Total weight of table plus decoration under 25 kilograms: felt glides are sufficient for feet from 1.5 cm diameter
  • Total weight 25 to 40 kilograms: felt glides plus regular position changes every few months
  • Over 40 kilograms or feet under 1 cm diameter: use additional washers made of metal or hard rubber
  • For oiled parquet: check more frequently, as oil offers less protection than sealing

Which Table Shapes Are Particularly Parquet-Friendly

Round or oval Side Tables with a wide central base distribute weight more favourably than models with four individual feet. A column base with 15 centimetres diameter generates only approximately 0.2 N/mm² surface pressure even at 30 kilograms total weight. Tables with cross bases or wide runners are also uncritical. Avoid feet that taper to a point or models with only three legs, as the load is concentrated on fewer points here.

How Do You Detect Damage in Time

Check the standing points of your table every three to four months. Slight impressions often disappear by themselves if you move the table briefly. If dents remain visible, you can allow them to swell with a little water and re-oil on oiled parquet. With sealed floors, careful warming with a hairdryer sometimes helps to raise the wood fibres again. Deeper damage requires professional sanding. The selection of Side Tables with parquet-friendly feet is large enough to opt for safe constructions from the outset.

Related products: Chairs, Display Cabinets, Resin and Fiberglass Sculptures. baroque mirrors. The complete range: Baroque Furniture.

Related categories: Chairs, Display Cabinets, Resin and Fiberglass Sculptures. The full range: Baroque Furniture.

Read more: Velvet Armchairs: Which Color for Direct Sunlight, Display Cabinet Under a Sloped Ceiling: Which Height Fits and What to Consider, Side Table at Sofa: Finding the Right Height Relative to Armrest, Display Cabinet in an Alcove: Which Depth for Limited Space, Column in the Room Corner: Which Height Draws the Eye Upward